| Customization: | Available |
|---|---|
| After-sales Service: | Issue 100% Recall |
| Certification: | ISO9001, TUV, GMP, ISO, CE |
|
Still deciding? Get samples of $ !
Request Sample
|
Suppliers with verified business licenses
The vibration absorber is a type of equipment that converts mechanical vibrational kinetic energy into heat energy, which is then absorbed by the high elastic deformation properties of the rubber material.
Its core functions include:
Energy dissipation: It consumes vibrational energy by utilizing viscous shear and elastic hysteresis effects.
Momentum isolation: It blocks the vibration transmission path, thereby reducing the risk of system resonance.
Buffer protection: It absorbs shock loads and extends the service life of the equipment.
Zhongmu Rubber is committed to developing both existing and new products, offering customers high-quality, high-performance isolation solutions.
Material type selection system
| Rubber type | dynamic modulus (MPa) | temperature range(-40ºC~+150ºC) | oil resistivity (70#) | Typical application |
| NBR | 2-5 | -40ºC~+120ºC | Volume change rate<10% | Automobile shock absorber, hydraulic cylinder bushing |
| EPDM | 3-8 | -50ºC~+180ºC | Volume change rate<5% | Building vibration isolation cushion, wind power sealing |
| SBR | 2-4 | -20ºC~+100ºC | Volume change rate<15% | Industrial floor damping pad |
| IIR | 1-3 | -40ºC~+80ºC | Volume change<8% | Precision instrument vibration absorber |
| criterion | test project | technical requirement |
| ISO 9001 | quality management system | Whole-process traceability |
| GB/T 10179 | Experimental method of rubber shock absorber | The deformation was <20% after 10 ^ 6 cycles |
| ASTM D3452 | Schematic drawing test | Rehome rate is> 70% |
| IEC 60068-2-6 | Environmental experiments | -40ºC ~ + 85ºC cycle aging |
| failure mode | analysis of causes | Improve the plan |
| surface checking | UV aging (> 2000h exposure) | Add UV absorber (carbon black N330) |
| The central hole collapsed | Localized overload (> 150% rated load) | Set the safety factor (≥2.5) |
| Damage recession | Liquid erosion (ASTM D471 test) | HNBR oil resistant rubber |
| Install stress cracking | Taper fitting (H7 / p6) | Add flexible spacer (Shaw 30-50A) |
){kind=link}